Supported link modes: 10baseT/Half 10baseT/FullĪdvertised link modes: 10baseT/Half 10baseT/Full I have the same problem, also on a vostro 200, replugging the cable sometimes solves the problem:
![problem detected with intel ich8 family usb universal host controller -2831 problem detected with intel ich8 family usb universal host controller -2831](https://images.anandtech.com/reviews/chipsets/intel/p35-launch/features-matrix.png)
PROBLEM DETECTED WITH INTEL ICH8 FAMILY USB UNIVERSAL HOST CONTROLLER 2831 MANUAL
Tcpdump on the router does not show any packet going from the computerĭuring DHCP or after manual configuration.Īfter a few(exact number may change) rmmod's & modprobe's, IPv4 can goes When the module is inserted, nothing complains, the RAs are recevied,īut ipv4 cannot be used on the interface.ĭHCP does not respond, and manual configuration does not allow packets to reach another computer. The problem appeared first in Debian 2.6.26-3 kernel, but I reproduced it with stock 2.6.28-rc3, as requested by Bastian Blank. Rmmod / modprobe module *sometimes* makes it working correctly, then the network interface is bringed up, DHCP responds, and communication can be established. The port's LED on switch blinks quickly all time, IPv6 RA's are recevied by the kernel, but no DHCP request packet reaches router, nor any ICMP one after manual configuration. It does not complain, but packets do not exit correctly. The e1000e kernel module does not initialize correctly, then the network cannot initialize.
![problem detected with intel ich8 family usb universal host controller -2831 problem detected with intel ich8 family usb universal host controller -2831](https://mycollectionhub.com/uploads/ckeditor/MCH_Artists_AT100003112002_1604427575.jpg)
Problem Description: I initially signaled this bug in debian BTS, see Small script to invoke mulitple phy register dumpsĮarliest failing kernel version: 2.6.28-rc3 Ethregs dumps on Vostro 200 bisect good/badĮ1000e patch dumps phy registers to msg log on ethtool -d